VMWare NAT on Windows 7

While I would never dream of switching my home workstation to a new version of Windows within its first few months on the market, particularly when it is still only in RTM, at work is a different story.

I could probably still get by using XP Pro on my workstation, and put Windows 7 in a VM, I find self-immersion to be the best method to fully learn a new OS, as it forces me to get it set up completely, otherwise I can't do work.

While I've run into a few annoyances thus far (no Daemon Tools or PowerISO, urg), nothing yet has been a show stopper... until I tried accessing the internet in my XP Active Directory administration virtual machine in VMWare using NAT.

Apparently Windows 7's new compartmentalized network security breaks VMWare's NATing ability. Note in the below screen shot how the VMWare Network adapter is identified by Windows as being on a public network, thereby disabling its connection.


I was able to still use Bridged networking within VMWare, but this was not practical at work since we have to specific each connected machine's MAC address in our DHCP tables to assign it an IP- a bit overkill for an only occasionally non-critical VM.

So after some digging and a bit of troubleshooting, I found a workable solution thanks, in part to this article, using Win7's Internet Connection Sharing (ICS). One important caveat to note is that Win7's networking has changed in a few minor ways that require a bit of deviation from the article. Below is a summary of steps:

1. Run the Virtual Network Editor as Admin
2. Go to Host Virtual Adapters tab, remove all VMNet instances (default are VMNet1 and VMNet8)
3. Click Apply
4. Click Add, select VMnet1
5. Click Apply
6. Go to the Host Virtual Networking tab
7. Click the > next to VMnet1 and change the address and subnet to use the Win7 ICS network (192.168.137.0 / 255.255.255.0) <- note how this deviates from the article
8. Click Apply
9. Go the NAT tab and select VMNet1
10. Click Edit and change the Gateway to the ICS gateway IP (192.168.137.1)
11. Click Apply and restart the NAT service
12. Go to the DHCP tab
13. Add VMNet1 and remove all others
14. Click Apply
15. Select Properties of VMNet1 in DHCP Tab
16. Enter a Start and End Address for DHCP (I used 192.168.137.50 to 192.168.137.75)
17. Click OK then Apply

19. Go to Network Connections in the Windows 7 Control Panel
20. Right Click on your Local Area Connection > Properties
21. Go to Share Tab and check both boxes (Allow other network users to connect through this computer's Internet connection and Allow other network users to control or disable the shared Internet Connection [optional])
22. Click OK

23. On each VM, go to Network settings and select Host Only Networking for every VM that needs to NAT out to the network

Done! Seemed to do the trick on my XP SP3 VMs, and now I can administer our AD tree and group policy!